Tried fit Pagoda-2.1 to my racing drone Manta. All went as it should 🙂 Here’s pagoda antenna short version with angle connector. No I need wait for little time to maiden my Manta Drone.

Got final version of Pagoda antenna cases. Made own project on Fusion 360. Wall of case is 0.8mm thick. All cases are made from PETG. It has better layer adhesion than ABS, smaller antenna shift frequency. Pagodas will be available in short version :        

The Pagoda antenna is circularly polarized antenna . This antenna was originally designed by Maarten Baert – http://www.maartenbaert.be/quadcopters/antennas/pagoda-antenna/ Maarten’s antenna is very nice antenna, and main advantage of that antenna is durability compared to cloverleaf. It’s good candidate to be best racing antenna. Marten designed also jig to soldering Pagoda antennas. But making it from Read more about New antenna – Pagoda-2.1[…]